3mm Mixed LEDs (4 Colors: Red, Yellow, Green, Blue) – KSH 15 at HIMASTORES Mombasa – best electronics in Kenya
Home / Displays / 3mm Mixed LEDs (4 Colors: Red, Yellow, Green, Blue)

3mm Mixed LEDs (4 Colors: Red, Yellow, Green, Blue)

SKU: HMJ114 Category: Displays
KSH 15.00
In Stock

Product Description

3mm Mixed LEDs (4 Colors: Red, Yellow, Green, Blue)

Standard Through-Hole LED Assortment for Electronics Projects

This kit contains 3mm round LEDs in four bright colors (Red, Yellow, Green, Blue). These through-hole components are perfect for Arduino projects, status indicators, and other DIY electronics [citation:1][citation:5][citation:8].

Four Colors in One Kit - Red, Yellow, Green, and Blue LEDs for status indicators, sensor projects, and creative lighting displays
Standard 3mm T1 Package Ideal for breadboarding and prototyping, with standard 2.54mm pin spacing [citation:1][citation:5]
Typical forward voltage range: 1.6V to 3.4V depending on color [citation:1][citation:3].
The long lead is the anode (positive) and the short lead is the cathode (negative) [citation:5].
Always use a current-limiting resistor (typically 220Ω) to prevent exceeding the max current of 20mA [citation:1][citation:5].

Technical Specifications

ParameterValue
:-:-
Package3mm (T-1) Round [citation:1]
Pin Spacing2.54mm [citation:1]
Max Forward Current20mA [citation:1][citation:5]
Typical Forward Voltage (Red/Yellow)1.8V to 2.4V [citation:1][citation:3]
Typical Forward Voltage (Green/Blue)2.8V to 3.4V [citation:1][citation:3]

This assorted set is ideal for Arduino and other MCU projects where you need clear visual feedback [citation:2][citation:5]. The different voltage requirements for each color ensure compatibility with a wide range of electronics [citation:3][citation:15].

Troubleshooting

LED not lighting:

  • Check the polarity (long lead positive, short lead negative).
  • Verify the forward voltage matches your circuit.
  • Ensure a current-limiting resistor is installed [citation:5].

Inconsistent brightness:

  • Adjust resistors per color as brightness can vary.
  • Keep all LEDs within their max current rating [citation:1][citation:5].